To remove main power from the server, use one of the methods shown in the following table. A STEADY ON green light illuminates when the server module SP and host are both powered on.įIGURE 2-1 Sun Fire X4170 Server Front Panel Power/OK LEDįIGURE 2-2 Sun Fire X4270 Server Front Panel Power/OK LEDįIGURE 2-3 Sun Fire X4275 Server Front Panel Power/OK LED The Power/OK LED illuminates a SLOW BLINK while the system is booting. Log in to the SP ILOM CLI and type: start /SYS Log in to the ILOM web interface for the server SP and select: Remote Control -> Remote Power Control->Power On. Use a stylus (or other pointed object) to momentarily press and release the recessed Power button on the front panel of the server.įor the location of the Power button on each type of server, see FIGURE 2-1, FIGURE 2-2, and FIGURE 2-3. The standby power state indicates that the server SP is active but the server host is powered off.įor the location of the OK/Power LED, see FIGURE 2-1, FIGURE 2-2, and FIGURE 2-3.Ģ.Ěpply full power to the server SP and host. In the Standby power state, the OK/Power LED on the front panel of the server blinks (0.1 second on, 2.9 seconds off). Verify that the server is in the standby power state. The following procedure assumes that the power cord is connected to the server.ġ. Power Off the Server Using the Service Processor Command-Line Interface.Refer to the following topics in this section to power on and off a server: Follow the electrostatic discharge safety practices as described in this chapter.Ensure that the voltage and frequency of your power source match the voltage and frequency inscribed on the equipment’s electrical rating label.Follow all cautions, warnings, and instructions marked on the equipment and described in the Sun Fire X4170, X4270, X4275 Servers Safety and Compliance Guide (820-5832).Follow all Sun cautions, warnings, and instructions marked on the equipment and described in Important Safety Information for Sun Hardware Systems (816-7190).The covers must be in place for proper air flow.įor your protection, observe the following safety precautions when setting up your equipment: Hazardous voltage present.Ĭaution - Equipment damage possible. This section describes important safety information that you need to know prior to removing or installing parts in the Sun Fire X4170, X4270, and X4275 Servers.Ĭaution - Never attempt to run the server with the covers removed.
0 Comments
Leave a Reply. |